How to Set Up Your AccuShot® Sprayer
Check out our how-to video and directions below!
Operating Instructions for Your AccuShot® Sprayer
STEP 1: Shake well before each use.
STEP 2: Remove sprayer from holster. Unwrap the tubing & gently pull tubing out.
STEP 3: Open flip-top closure.
STEP 4: Securely snap the hose plug into opening in cap until it snaps into place.
STEP 5: Slide switch on hose plug counterclockwise to "OPEN".
STEP 6: Remove plastic tab near bottom of sprayer to activate batteries.
STEP 7: Twist nozzle to adjust spray from CLOSE to SPRAY or STREAM.
STEP 8: When priming the sprayer, hold sprayer level to ground. Squeeze & hold trigger until liquid comes out of the nozzle. Sprayer may not prime if it is held at an angle. Once primed, it will spray in any direction.
After Use:
- Twist sprayer nozzle completely to CLOSE position.
- Turn hose plug switch clockwise to “CLOSED.”
- Secure sprayer tip down in holster.
- Failure to adjust nozzle completely to CLOSE position and properly secure sprayer in holster may result in leakage and damage to property or injury to people or animals
To Replace Batteries:
- Use screwdriver to open battery compartment.
- Remove used batteries and insert new AA batteries in correct positions as marked per diagram inside of battery compartment. Never insert the positive end where the negative end belongs and vice versa. Always use a complete set of new batteries of the same type when replacing batteries. Never mix alkaline, carbon-zinc or rechargeable batteries.
- Securely close battery compartment door.
- Always follow manufacturer’s recommendations for use and disposal of batteries.
Additional Operating Notes:
Do not submerge in water. Before each use, inspect sprayer carefully making sure hose is flexible and not kinked, worn or cracked, and that all connections are tight. When storing sprayer for prolonged periods, remove batteries.