PRODUCT DESCRIPTION:
Spectracide® Weed & Grass Killer2 is a non-selective herbicide that kills weeds and grasses down to the root. Rainproof in just 15 minutes, this powerful formula delivers results in as fast as 3 hours. That means you can plant new flowers, trees and shrubs in the treated area after just 1 day. The AccuShot® wand reduces hand fatigue with a continuous action power sprayer – no pumping or squeezing, just press to spray. This battery-powered wand is also extendable for improved accuracy. Spray to completely cover the leaves of the target vegetation so the formula can be absorbed on all plant surfaces. Avoid spraying this product on desirable plants, lawn grasses, shrubs or trees.This product is a non-selective herbicide that will kill any vegetation contacted. It enters plants through the leaves and moves down to the roots. This will ensure that the entire plant is eliminated. Avoid direct spray or drift onto desirable plants, lawn grasses, shrubs, and trees. Protect desirable plants and vegetation with a piece of plastic or cardboard. If desirable plants are accidentally sprayed, wash plants with water immediately.
Ingredients
Diquat Dibromide:0.12%
Fluazifop-p-butyl:0.06%
Dicamba, Dimethylamine salt:0.04%
Other Ingredients:99.78%
Total:100%
SAFETY DATA SHEETS & PRODUCT LABELS:
SDS
Directions For Use:
STOP. Read Entire Label Before Use.It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not allow people or pets to touch treated plants until the sprays have dried.
APPLICATION RESTRICTIONS:
Do not apply this product in a way that will contact any person or pet, either directly or through drift. Only persons applying this product may be in the area during application. Do not mow, cut or otherwise disturb treated vegetation, weeds or plants for at least seven days following application. Do not use on or around edible feed or food crops.OPERATING INSTRUCTIONS FOR ACCUSHOT SPRAYER:
- 1. Shake well before use.
- 2. Remove sprayer from side holster. Unwrap the tubing. Gently pull tubing out.
- 3. Open flip-top closure.
- 4. Securely snap the hose plug into opening in cap until it snaps into place.
- 5. Slide switch on hose plug counterclockwise to "OPEN."
- 6. Remove plastic tab near bottom of sprayer to activate batteries.
- 7. Twist nozzle to adjust spray from CLOSE to SPRAY or STREAM.
- 8. When priming the sprayer, hold sprayer level to the ground. Squeeze and hold trigger until liquid comes out the nozzle. Sprayer may not prime if it is held at an angle. Once primed, it will spray in any direction.
HOW TO USE THE ACCUSHOT SPRAYER:
- 1. Aim toward target site, and away from people and pets.
- 2. To improve accuracy, use slider to extend wand.
- 3. Press the trigger to spray.
- 4. Release the trigger to stop spray.
AFTER USE:
- 1. Twist sprayer nozzle completely to CLOSE position.
- 2. Turn hose plug switch clockwise to "CLOSED."
- 3. Secure sprayer tip down in holster.
- 4. Failure to adjust nozzle completely to CLOSE position and properly secure sprayer in holster may result in leakage and damage to property or injury to people or animals.
Keep reusable AccuShot® Sprayer for use with Spectracide® Weed & Grass Killer3.
TO REPLACE BATTERIES:
- 1. Use screwdriver to open battery compartment.
- 2. Remove used batteries and insert four new AA batteries in correct positions as marked per diagram inside of battery compartment. Never insert the positive end where the negative end belongs and vice versa. Always use a complete set of new batteries of the same type when replacing batteries. Never mix alkaline, carbon-zinc or rechargeable batteries.
- 3. Securely close battery compartment door.
- 4. Always follow manufacturer's specifications for use and disposal of batteries.
ADDITIONAL OPERATING NOTES:
- • DO NOT submerge in water.
- • Before each use, inspect sprayer carefully, making sure hose is flexible and not kinked, worn or cracked and that all connections are tight. When storing sprayer for prolonged periods, remove batteries.
HOW TO USE:
Spectracide® Weed & Grass Killer2 is pre-mixed and ready to use and is formulated for “spot” treatment of weeds and grasses. Use it on driveways and walkways, or around fences, trees, flower beds, shrubs and other areas in your yard.
HOW TO APPLY*:
- • Completely cover the leaves of the target vegetation. Do not overspray.
- • Sprayed plants begin yellowing and wilting in about 24 hours, with complete kill, including the roots, in one to two weeks.
- • Protect desirable plants with a piece of plastic or cardboard.
- • If desirable plants are accidentally sprayed, wash plants with water immediately.
*Visual symptoms and time to complete kill will depend on weed and grass type, temperature and application rate.
FOR LAWN RENOVATION/REPLACEMENT:
- 1. Determine size of area to be treated — measure length and width in feet, then multiply to determine coverage area in square feet (length x width).
- 2. Use this product to remove the old lawn and existing weeds and grasses.
- 3. For best results, apply in spring or fall, when daytime temperatures are at least 60°F.
- 4. Under dry conditions, water lawn every other day for a week before applying this product.
- 5. Do not mow for seven days before or after treatment.
- 6. One gallon treats 300 sq ft.
WHEN TO APPLY:
- • For best results, apply during warm, sunny weather (above 60°F) when weeds are actively growing. Rainfall or watering 15 minutes after application will not wash away effectiveness.
- • To avoid drift to desirable plants, apply when the air is calm.
- • WHEN TO REPLANT: All ornamental flowers, trees and shrubs may be planted one day after application.
TIPS FOR REPLANTING:
- • Wait seven days after last application to rake, till or replant with seed or sod.
- • Rake up and remove loosened thatch or debris.
- • Mix in starter fertilizer and soil amendments, if needed. Level the soil.
- • Apply seed according to directions on seed package, or install sod. Grass seed must have good contact with soil to germinate and grow.
- • Keep area moist for two weeks to establish new lawn, then water as needed.
Storage & Disposal:
Storage & Disposal:
Pesticide Storage: Turn the nozzle to "CLOSE" position. To prevent leakage, place sprayer in holster. Store this product only in its original container in a secure storage area away from sources of heat or open flame and in an area inaccessible to children and pets. Keep from freezing.
Pesticide Disposal: DO NOT discard the AccuShot® Sprayer. Keep the AccuShot Sprayer for use on Spectracide® Weed & Grass Killer3. Nonrefillable container. Do not reuse or refill this container unless the directions for use allow a different (concentrated) product to be diluted in the container. If empty: Place in trash or offer for recycling if available. If partly filled: Call your local solid waste agency for disposal instructions. Never place unused product down any indoor or outdoor drain.
Precautionary Statement:
Precautionary Statements
Hazards to Humans and Domestic Animals
CAUTION. Causes moderate eye irritation. Avoid contact with eyes or clothing. Personal Protective Equipment (PPE): Wear long-sleeved shirt, long pants, shoes and socks.
User Safety Recommendations: Users should wash hands before eating, drinking, chewing gum, using tobacco or using the toilet. Users should remove clothing immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. Users should remove clothing and personal protective equipment immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.
User Safety Recommendations: Users should wash hands before eating, drinking, chewing gum, using tobacco or using the toilet. Users should remove clothing immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. Users should remove clothing and personal protective equipment immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into clean clothing.
Environmental Hazards:
This pesticide is toxic to aquatic invertebrates. Do not apply directly to water or to areas where surface water is present or to intertidal areas below the mean high water mark. Do not contaminate water when disposing of equipment washwaters or rinsate. To protect the environment, do not allow pesticide to enter or run off into storm drains, drainage ditches, gutters or surface waters. Applying this product in calm weather when rain is not predicted for the next 24 hours will help to ensure that wind or rain does not blow or wash pesticide off the treatment area.
First Aid:
If in Eyes:
- • Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye.
- • Call a Poison Control Center or doctor for treatment advice.
If on Skin or Clothing:
- • Take off contaminated clothing.
- • Rinse skin immediately with plenty of water for 15-20 minutes.
- • Call a Poison Control Center or doctor for treatment advice.
NOTICE:
To the extent required by applicable law, buyer assumes all responsibility for safety and use not in accordance with directions.
Questions & Comments? Call 1-800-917-5438 or visit our website at www.spectracide.com
